PeniMaster PRO belt expander
PeniMaster PRO belt expander system operating instructions
- 3 penis belt expanders in one system
- Hip belt wearing variant
- Shoulder belt wearing variant
- Knee belt wearing variant
- Operating instructions (PDF)
The belt pulling force generator is connected to the glans using the fixing unit PeniMaster PRO so that the pulling force can be transferred to the penis. Depending on the desired wearing variant, the other end of the belt is either attached to the body (upper leg, knee) or to the clothes (trousers) by means of the fixing clip.
Hip belt wearing variant
- Pulling force nearly equal in all body positions
- Stronger pulling force on one side of the penis
- Advantageous for corrections of curvatures of the penis to the left- or right-hand side
Shoulder belt wearing variant
- axially symmetrical elongation in an upwards direction similar to the procedure with a rod expander
- pulling force varies depending on the position of the upper part of the body
- For the purposes of privacy a shirt should be worn protruding over the trousers.
Knee belt wearing variant
- axially symmetrical elongation in a downwards direction similar to the procedure with a rod expander
- pulling force varies depending on the position of the leg
- dynamic (increasing/decreasing) elongation load at every step = a good complementation of the training for elongation variants within the framework of which the pulling force remains constant over extended periods of time
- If you leave your house you should wear trousers with wide legs for this wearing variant.